0 avis
Hot water immersion: Maintaining core body temperature above 38.5°C mitigates muscle fatigue
Archive ouverte
International audience. Purpose Hot water immersion (HWI) has gained popularity to promote muscle recovery, despite limited data on the optimal heat dose. The purpose of this study was to compare the responses of two exogenous heat strains on core body temperature, hemodynamic adjustments, and key functional markers of muscle recovery following exercise‐induced muscle damage (EIMD). Methods Twenty‐eight physically active males completed an individually tailored EIMD protocol immediately followed by one of the following recovery interventions: HWI (40°C, HWI 40 ), HWI (41°C, HWI 41 ) or warm water immersion (36°C, CON 36 ). Gastrointestinal temperature ( T gi ), hemodynamic adjustments (cardiac output [CO], mean arterial pressure [MAP], and systemic vascular resistance [SVR]), pre‐frontal cortex deoxyhemoglobin (HHb), ECG‐derived respiratory frequency, and subjective perceptual measures were tracked throughout immersion. In addition, functional markers of muscle fatigue (maximal concentric peak torque [ T peak ]) and muscle damage (late‐phase rate of force development [RFD 100–200 ]) were measured prior to EIMD (pre‐), 24 h (post‐24 h), and 48 h (post‐48 h) post‐EIMD. Results By the end of immersion, HWI 41 led to significantly higher T gi values than HWI 40 (38.8 ± 0.1 vs. 38.0°C ± 0.6°C, p < 0.001). While MAP was well maintained throughout immersion, only HWI 41 led to increased (HHb) (+4.2 ± 1.47 μM; p = 0.005) and respiratory frequency (+4.0 ± 1.21 breath.min −1 ; p = 0.032). Only HWI 41 mitigated the decline in RFD 100–200 at post‐24 h (−7.1 ± 31.8%; p = 0.63) and T peak at post‐48 h (−3.1 ± 4.3%, p = 1). Conclusion In physically active males, maintaining a core body temperature of ~25 min within the range of 38.5°C–39°C has been found to be effective in improving muscle recovery, while minimizing the risk of excessive physiological heat strain.
Consulter en ligne
Suggestions
Du même auteur
